Install (43) heat pump systems with ductwork.(mixed-use) units are self contained and condensers on roof. (41 resd) (2 commercial)

Wiring a unit apartment building. All new wiring and devices gfi,new 16 amp 3 phase service,new phone and cable in each unit per 2008 nec (apt bldg)west district install new fa wiring,pull stations and smokes per nfpa 72

Install a new auto wet sprinkler throughout per nfpa 13 and 13r, 4" line, fdc

Exterior front of new construction - the installation will compy with the philadelphia plumbing code 2004

Installation of crawl space exhaust ventilation system with exhaust fan, ductwork and motorized dampers as per approved plans.

New 3-story bldg with dwelling units, fitness room, office and cellar.

100amp temp power on pole for job site with 2-gfcis from 9 23 15 to 3 23 15 as per 2008 nec (west district)

Interior plumbing alterations for a new (3)story building with (40)dwelling units, fitness room, office & cellar to a point 50" outside only - note: additional permit(s) required for the backflow prevention containment device, exterior & sewer water connections to the city mains - the installation will comply with the approved plans and the philadelphia plumbing code 2004

Sealing existing lateral pa20151970180(commercial)self certifications are no longer permitted","all excavations and plumbing trenches in excess of 5 ft in depth must have approved shoring in place at the time of inspection"

The complete demolition of an existing building on site (one (1)- 1 story detached structure) as shown per approved plans and submitted documentation. All permitted demolition activity to be in accordance with approved site safety demolition plan & such plan to be maintained on site at all times in accordance with code bulletin b-1302. Full sidewalk closure required as reflected on approved site plan and in accordance with section 3306 of the ibc. Separate street closure permit required prior to start of work. Any deviation will require an amended building permit. If field conditions vary, contact professional engineer prior to the start of any work.