1. Remove parapet wall cap2. Install new 16 ounce copper step flashing and counter flashing(16)3. Apply new mortar cap on top of parapet wall. 4. Install new vermont slate to match the existing as close as possible. Note home is leaking, if we can get emergency permit on above repair that would be great.

Repair and/or replace underlayment as necessary replace/install natural slate roofing as needed to match existing using copper nails. Install/repair copper gutters, flashing and vents as needed, removing any galvanized flashing install/reinstall ceramic or concrete v-style or terra cotta ridge tiles metal cap-flashing on the parapets is not allowed replace any wood siding and trim as necessary to match existing all repair/replacement work shall match existing in color, size, material, detail, profile and exposurenote: trash chutes are required for removal of debris from all roofs all work must conform to standard vcc policies & guidelines permit does not allow for cap flashing on parapet or surrounding wallstorch-applied roofing is not permitted in the vieux carr.

- replace existing courtyard gate with new three leaf 18 panel gate- widen the existing opening to 8-6" in width to accommodate the new gate- remove planter in courtyard and repave to match existing adjacent materials

-paint to match existing walls... Masonry is not to be painted wooden elements including doors, windows, trim... White, semigloss shuttersfrench quarter green, semigloss balcony deckinggrey ironwork ... Black

General improvements to courtyard

Proposal to install three (3) gas lanterns above rear courtyard doorway openings, per ac approval of 12/10/13, and materials received 11/07/13 and stamped vcc approved 12/10/13, as follows: one (1) riccas 23h x 13. 5w copper and glass fixture with yoke bracket mounted to the eaves of the roof overhang, centered above each of the three arched door-openings on the rear elevation of the main cottage.

To remove existing, unpermitted metal cap flashing from parapet of service buildingremove deteriorated roofing material adjacent to parapetrepair/replace underlayment as necessaryinstall new 16 oz. Copper step flashing and counter flashing apply new mortar cap to top of parapet wall per vcc formulas and standard details (attached)install new vermont natural slate to match existing using copper nails as needed adjacent to parapet

Remodel kitchen and bathrooms

Remove all existing, unpermitted and or unshielded light fixturesinstall remcraft 1 series ceiling mounted downlight (single light) or remcraft 21 series ceiling mounted downlight (double light) to the underside of the balcony gallery centered over the window door openingsfixtures shall be painted to match adjacent building surface. All wiring shall be placed in conduitsall conduits shall be placed along the inside corners of building surfaces as much as possible, such as along gallery balcony purlins at the deck line, and painted to match the adjacent surfaces. All fixtures shall use lamps with the following criteria: 3000k color temperature, 80+ color rendering index, and (600-800, residential) (800-1200, commercial) lumens per bulbremove existing standing seam metal abat-vent and gutters and replace with standing seam copper abat-vent and 6" half-round copper gutters. Remove replace deteriorated wood soffit & touch up paint. Repoint bricks where mortar is missing on barracks side of rea

Non structural renovation to single family dwelling. Work will include exterior work only as approved by vcc.

Masonry: rework bulge in bricks at barrack st wall, repointing cracked mortar at same area, necessary because of water infiltrationtermite: treatment of termites, based on vcc recommendation method, attached is proposal from absolute termite

Proposal to install three (3) gas lanterns above rear courtyard doorway openings, per ac approval of 12 10 13, and materials received 11 07 13 and stamped vcc approved 12 10 13, as follows: one (1) riccas 23h x 13. 5w copper and glass fixture with yoke bracket mounted to the eaves of the roof overhang, centered above each of the three arched door-openings on the rear elevation of the main cottage.

Repair and or replace underlayment as necessary replace install natural slate roofing as needed to match existing using copper nails. Install repair copper gutters, flashing and vents as needed, removing any galvanized flashing install reinstall ceramic or concrete v-style or terra cotta ridge tiles metal cap-flashing on the parapets is not allowed replace any wood siding and trim as necessary to match existing all repair replacement work shall match existing in color, size, material, detail, profile and exposurenote: trash chutes are required for removal of debris from all roofs all work must conform to standard vcc policies & guidelines permit does not allow for cap flashing on parapet or surrounding wallstorch-applied roofing is not permitted in the vieux carr.

To remove existing, unpermitted metal cap flashing from parapet of service buildingremove deteriorated roofing material adjacent to parapetrepair replace underlayment as necessaryinstall new 16 oz. Copper step flashing and counter flashing apply new mortar cap to top of parapet wall per vcc formulas and standard details (attached)install new vermont natural slate to match existing using copper nails as needed adjacent to parapet