Content | Date | Cost | Contractor Rank | Address | Contractor |
---|---|---|---|---|---|
SCORE 95 Deconvert basement Permit type: Permit - electric wi | Permit id: 100401072 | |||||
SCORE 59 Convert existing 2 d. U. To single family residence & interioralterations in basement and 1st floor as per plan. Permit type: Permit - renovation/ | Permit id: 100405753 | |||||
SCORE 95 Interior alterations in existing basement and first floor of single family residence as per plan. (basement for storage use only) conditional approval subject to audit and field inspections Permit type: Permit - renovation/ | Permit id: 100424463 | |||||
SCORE 95 Replace existing 100 amp panel with new 100 amp panel. Reason for changing out out existing electric panel is current neutral bar has been melted do to exccesive heat from the neutral wires not being terminated correctly. When the neutral wire is not terminated correctly is will cause an electric arc, which in turn causes excessive heat which causes a neutral bar to melt. Value: $1,700 Contractor: Docksun Electric Permit type: Permit - electric wi | Permit id: 100453944 | |||||
SCORE 95 Interior alterations in existing basement and first floor of single family residence as per plan. (basement for storage use only) conditional approval subject to audit and field inspections Permit type: Permit - renovation/alteration | Permit id: 100424463 | |||||
SCORE 59 Convert existing 2 d. U. To single family residence & interioralterations in basement and 1st floor as per plan. Permit type: Permit - renovation/alteration | Permit id: 100405753 | |||||
SCORE 95 Deconvert basement Permit type: Permit - electric wiring | Permit id: 100401072 | |||||
SCORE 95 Remove and replace 15 sqft of masonry on north elevation and 1 sqft of masonry on south elevation with same like and kind bricks, where most needed. All work same as existing. No structural work. Subject to field inspections. Permit type: Permit - easy permit process | Permit id: 100709108 | |||||
SCORE 95 Replace existing 1 amp panel with new 1 amp panel. Reason for changing out out existing electric panel is current neutral bar has been melted do to exccesive heat from the neutral wires not being terminated correctly. When the neutral wire is not terminated correctly is will cause an electric arc, which in turn causes excessive heat which causes a neutral bar to melt. Value: $1,700 Contractor: Docksun Electric Permit type: Permit - electric wiring | Permit id: 100453944 | |||||
SCORE 56 Plumbing work only to existing sfr: remove catch basin, route sink stack to bulding drain. Remove 4"" c. I. Coupling on main stack. Install accessable clean out for main stack. Redo waste and vent for laundry sink into pit. Run floor drains in bsmt. To pit. Permit type: Permit - easy permit process | Permit id: 100454568 |