Repave parking lot at oregon avenue

Supply & install lp panels, conduit, wire and lighting as per nec 2008 south district

Furnish install lighting,switching,receptacle, kva transformer,1 amp panel, combination motor starter,fire alarm as per 2008 nec nfpa 72

Removal of existing exterior fencing, footings,concrete planters, new construction of structural steel polycarbonate screen wall fencing and footings,

Structural work to include removal of existing exterior fencing, footings,concrete planters, new construction of structural steel polycarbonate screen wall fencing and footings, civil - site improvements

Change adress of job from 8 0regon ave to 2619 s chris columbus blvd

Add make up air unit and associated ductwork, exhaust fan and airduct. Install gas pipe as per plans.

Installation of new bathrooms in existing building (training facility)

For the installation of a new fire suppression system in an existing structure in accordance with nfpa 2007, standard 13.

Renovation to existing bldg to provide additional classroom space with incidental work included.

Supply & install power, lighting, fa devices, existing panels lhb & ulb & transformers t1 & t2 are existing to be reused, enable rtu-1,rtu-2 & wh1-feed from existing bus duct switches as per 2008 nec & nfpa 72 (training facility)

Furnish and install new sprinkler connections in new training classrooms 114 & 115 in accordance with nfpa 13 as per plans.

Install 28 roof drains and storm piping and new connection to sewer in oregon ave

For a training facility (splicing training) accessory to an existing peco facility witin an existing structure on the same lot with other uses as previously approved.

For the construction of new facade and for the replace existing windows as per plans.

Renovation to existing peco bldg to create additional training rooms.

Remove and replace one gasoline fuel suction pump, fuel island piping conduit and related equipment. Existing u. G. Fuel storage tank to remain. Replace concrete island and bituminous paving as noted on plans, with dispensing . All work per nfpa standards, to include nfpa 2003, standard 30a. Certificate of completion from the licensed contractor must be submitted upon completion of the installation indicating full compliance with applicable codes, standards and manufacturers instructions. Separate permit required for electrical work.

Remove & replace overhead heaters

For the removal and replacement of warm-air, gas fired unit heaters in an existing facility.

Reconfiguration of existing parking lot, repaving of existing parking lot, line stripping, new accessible spaces and route, curb and driveway macadam work, and general site improvements, as per engineered plans. No stormwater management pwd or underground utility work this permit.

Renovation to existing bldg to create a training facility

Install preaction system and tie into existing sprinkler system

Hvac to include installation of indirect fired heaters as per approved plan.

Installation of three (3) packaged roof top units (rtus), (11) vav boxes, (38) new registers diffusers with associated ductwork to an existing training facility. All work to be done in accordance with approved plans.