Installation of pelco spectra iii camera on traffic light pole at 19' above ground level, we will also be mounting a network box at 11' above ground level. We will be attaching the camera to the network box via low voltage cableing routed inside the traffic light pole. We will be powering the network box from the nearest traffic controller box located at street level. This will be a 120vac circuit tapped off the traffic controller box running through existing manholes at the intersection.

Tuck point terracotta-first fl north elevation, install steel bar to support chimneys from falling down-between two chimneys in the middle of the building, spot tuck point all parapet walls and chimneys, tuck point all coping tile, remove and install new caulk north elevation, rebuild bricks at top of north -east & north-west corners,patch concrete stairs & poor one concrete step on southside,rebuild top part of south west chimney approx 4' and, rebuild one chimney in middle of building and pour

Masonry repair work: rebuild west parapet wall common bricks (approximately 100 sq. Ft.), replace bad bricks as needed. All work same as existing.

Tuckpoint & rebuild parapet. Replace (2) lintels (not longer than 6'). Reslope existing limestone sill (not longer than 6') (no structural work)- all work same as existing; subject to field inspection

Masonry repair work: rebuild west parapet wall common bricks (approximately 1 sq. Ft.), replace bad bricks as needed. All work same as existing.

Installation of pelco spectra iii camera on traffic light pole at 19 above ground level, we will also be mounting a network box at 11 above ground level. We will be attaching the camera to the network box via low voltage cableing routed inside the traffic light pole. We will be powering the network box from the nearest traffic controller box located at street level. This will be a 120vac circuit tapped off the traffic controller box running through existing manholes at the intersection.

Tuckpoint & rebuild parapet. Replace (2) lintels (not longer than 6). Reslope existing limestone sill (not longer than 6) (no structural work)- all work same as existing; subject to field inspection

Tuck point terracotta-first fl north elevation, install steel bar to support chimneys from falling down-between two chimneys in the middle of the building, spot tuck point all parapet walls and chimneys, tuck point all coping tile, remove and install new caulk north elevation, rebuild bricks at top of north -east & north-west corners,patch concrete stairs & poor one concrete step on southside,rebuild top part of south west chimney approx 4 and, rebuild one chimney in middle of building and pour new concrete cap s. A. E., subject to field inspection

Self certification process, interior rehabilitation build-out of existing beauty salon on second floor as per plans in existing 33 story masonry building.