200amp service wire throughout outlets lighting with finish basement and hard wire smoke per 2008 nec (sfd)

Ez permit ductwork & warm-air appliances- for the installation of new ductwork, registers grilles diffusers, and warm-air appliances as per attached standard. Deviations from this standard will result in permit revocation and require submission of construction plans. Duct work 2 gas furnaces 92% 40,0 btu 2 ton coil 2 ton ac unit 13 seer

"applicant agrees to limit the construction to comply with ez permit standard for interior alterations, dated february, 2007. Deviations from this standard will result in the revocation of this permit and imposition of further penalties."separate permits required for plumbing, electrical and mechanical work

Installation of 5" lateral and curb trap,fai. Install 1" rfss combined (sfd)self certifications are no longer permitted","all excavations and plumbing trenches in excess of 5 ft in depth must have approved shoring in place at the time of inspection"

Proposed single family dwelling 3 story with a roof top deck and pilot house. New construction.

4 lavs,2 wc,1 ks and 1 tub (sfd)the installation shall comply with the philadelphia plumbing code, 2004

Automatic sprinkler system w. One (1) inch combined fire & domestic service line for a previously approved three (3) story above grade plane residential building; automatic sprinkler system install per nfpa 13d.

Tear down existing 2 story front and rear masonry walls. Replace with 2 x 6 framing, plywood sheathing and brick veneer as per 2009 irc. Masonry front wall with veneer - remove existing brick front wall, 4 square feet. Frame new front wall with 2 x 6 studs and plywood sheathing. New framing to be structurally fastened to existing party walls and inspected prior to starting brickwork. Foundation wall to extend to first floor at 8 inch width. Start 4 inch brick veneer at first floor level, install brick ties every 32 inches, vertical and horizontal. Physically tie in every 4 feet at adjoining wall. Windows and door same location. Install capping, flashing and weep holes as per code requirements.